Subaru Crosstrek Service Manual: Disassembly
FRONT SUSPENSION > Front Strut
DISASSEMBLY
1. Using a coil spring compressor, compress the coil spring - front.
2. Using a hexagon wrench to prevent strut rod from turning, remove the self-locking nut with ST.
CAUTION:
When installing the coil spring compressor to the coil spring, follow the operation manual accompanied with the coil spring compressor during operation.
Preparation tool:
ST: STRUT MOUNT SOCKET (20399AG000)
NOTE:
The installing position of coil spring compressor varies depending on the coil spring shape and winding number.
3. Remove the strut mount - front, spacer - front strut and spring seat - front strut UPR from the strut.
4. Gradually decrease the compression pressure of compressor, and remove the coil spring - front.
5. Remove the dust cover - inner and the helper - front strut.
Removal
FRONT SUSPENSION > Front StrutREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the front strut assembly.(1) Place an alignment mark (a) on the adjusting bolt and the strut. ...
Disposal
FRONT SUSPENSION > Front StrutDISPOSALCAUTION:• Before handling the strut damper and shock absorber, be sure to wear goggles to protect eyes from gas, oil and cutting powder.• Do not di ...
Other materials:
Ventilator control
Center and side ventilators
Center ventilators
Open
Close
Side ventilators
Open
Close
To adjust the flow direction, move the tab.
To open or close the ventilator, turn the
thumb-wheel up or down. ...
Replacing bulbs
WARNING
Bulbs may become very hot while
illuminated. Before replacing bulbs,
turn off the lights and wait until the
bulbs cool down. Otherwise, there is
a risk of sustaining a burn injury.
CAUTION
Replace any bulb only with a new
bulb of the specified wattage.
Using a bulb of differe ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Mass Air Flow and Intake Air Temperature SensorINSPECTION1. CHECK THE MASS AIR FLOW SENSOR UNIT1. Connect the battery positive terminal to terminal No. 3 and the battery ground terminal to terminal No. 4, the circuit tester positive terminal to terminal No. 5 ...
