Subaru Crosstrek Service Manual: Assembly
CLUTCH SYSTEM > Clutch Pedal
ASSEMBLY
1. Install the stopper and pedal pad to the clutch pedal.
2. Install the clutch switch to the pedal bracket.
3. Clean the pedal bushing holes of the clutch pedal and the brake pedal, apply grease, and install the pedal bushings.
4. Install the clutch pedal, brake pedal and lever to the pedal bracket, and fix with a spring pin.
5. Install the assist rod A, assist rod B, assist bushing and assist spring to the clutch pedal and pedal bracket.
Removal
CLUTCH SYSTEM > Clutch PedalREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General ...
Disassembly
CLUTCH SYSTEM > Clutch PedalDISASSEMBLY1. Remove the clutch switches.2. Remove the clip, assist spring, rod and bushing.(A)Clip(B)Assist spring(C)Assist rod(D)Bushing(E)Clevis pin3. Remove the spri ...
Other materials:
Adjustment
AIRBAG SYSTEM > Roll ConnectorADJUSTMENTCAUTION:• Do not rotate the roll connector to more than the specified number of turns. Otherwise, the roll connector internal wire may be broken.• When determining the end stop, rotate the connector slowly without applying excessive force. Apply ...
Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remove the snap ring from outer race (PTJ).4. Remove the outer race (PTJ) from shaft assembly.5. Wipe off ...
Note
POWER ASSISTED SYSTEM (POWER STEERING) > Power Steering SystemNOTEFor procedure of each component in the power steering system, refer to the respective section.• Steering wheel: Steering Wheel">• Universal joint assembly - steering: Universal Joint">• Steering ...
