REAR SUSPENSION > Wheel Alignment
INSPECTION
NOTE:
Measure and adjust the front and rear wheel alignment at a time. Refer to “Wheel Alignment” in “FRONT SUSPENSION” section for measurement or adjustment of wheel alignment.
• Inspection: Wheel Alignment > INSPECTION">
• Adjustment: Wheel Alignment > ADJUSTMENT">
Dtc b2300 rear radar circuit low
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2300 REAR RADAR CIRCUIT LOWDTC detecting condition:• Short circuit to ground in the harness between radar sensor and outer mirror assembly• Ground short circuit of ...
Operation
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlOPERATION1. While the VDC sequence control is performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve is operated.2. VDC sequence control can be started by S ...
Dtc p2530 ignition switch run position circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Faulty TCM operationCAUTION:Use the check board when measuring the TCM te ...