Subaru Crosstrek Service Manual: Transmission control module (tcm) i/o signal

General description

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Learning ControlGENERAL DESCRIPTION• Follow the messages displayed on the Subaru Select Monitor when working.• When the following work ...

Electrical specification

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Transmission Control Module (TCM) I/O SignalELECTRICAL SPECIFICATIONNOTE:Measure after warming up.ItemTerminal No.Measuring conditionMeasurement v ...

Other materials:

Passive arming (models without "keyless access with push-button start system")
Passive arming mode When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED. Passive arming mode When passive arming mode has been programmed by ...

Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the lid assembly - sunroof. Glass Lid > REMOVAL">3. Remove the trim panel - roof assembly. Roof Trim &g ...

Dtc p2758 torque converter clutch pressure control solenoid control circuit stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2758 TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:The e ...