Subaru Crosstrek Service Manual: Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Module (TCM)
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
NOTE:
For model with battery sensor, disconnect the ground terminal from battery sensor.
2. Remove the instrument panel lower cover. Instrument Panel Lower Cover > REMOVAL">
3. Move the lock lever in the arrow direction while pressing the lock button, and disconnect the connector.
(A) | Lock button |
(B) | Lock lever |
4. Remove the TCM.
5. Remove the TCM from the bracket.
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Module (TCM)INSTALLATION1. Install the bracket to the TCM.2. Install the TCM to the bracket.Tightening torque:7.5 N·m (0.8 kg ...
Other materials:
Removal
DRIVE SHAFT SYSTEM > Front Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axl ...
Wiring diagram
CONTROL SYSTEMS > AT Shift Lock Control SystemWIRING DIAGRAM1. MODEL WITHOUT PUSH BUTTON IGNITION SWITCH(1)Ignition switch(5)TCM (shift range information)(9)Battery(2)Stop light and brake switch(6)Key lock solenoid(10)ECM (delivery (test) mode signal)(3)Key warning switch(7)Shift lock solenoid(11 ...
Keyless access with push-button start system (if equipped)
The keyless access with push-button start
system allows you to perform the following
functions when you are carrying the
access key.
Locking and unlocking of the doors and
rear gate
Starting and stopping the engine. For
detailed information, refer to "Starting and
stopping engine (mod ...
