Subaru Crosstrek Service Manual: Installation

1. Install the bracket to the TCM.

2. Install the TCM to the bracket.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

3. Install the TCM.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

4. Install the harness connector to TCM.

NOTE:

Move the lock lever in the arrow direction, and confirm that a clicking sound is heard.

5. Install the instrument panel lower cover. Instrument Panel Lower Cover > INSTALLATION">

6. Perform the operation of AT learning mode. Learning Control">

Transmission control module (tcm)

Removal

Other materials:

Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...

34
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code34The vehicle has been driven at a speed higher than set speed for a long time (approximately 10 minutes) during cruise driving.This cancel code is detected when driving for a long period of time at a speed higher than app ...

Dtc p014c a/f / o2 sensor slow response - rich to lean bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P014C A/F / O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perfor ...