Subaru Crosstrek Service Manual: Removal
CLUTCH SYSTEM > Flywheel
REMOVAL
1. Remove the transmission assembly. Manual Transmission Assembly > REMOVAL">
2. Remove the clutch cover and clutch disc. Clutch Disc and Cover > REMOVAL">
3. Attach the ST.
| ST 498497100 | CRANKSHAFT STOPPER |
(A) | Flywheel |
4. Remove the flywheel and crankshaft position sensor plate.
5. Drive out the pilot bearing from flywheel.
Inspection
CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectivene ...
Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the ...
Other materials:
Installation
MECHANICAL(H4DO) > Cylinder BlockINSTALLATION1. Apply engine oil to the crankshaft bearing, and install the crankshaft bearing to the cylinder block.CAUTION:• Place a wood board wrapped with a waste cloth to prevent the knock pin damage and to stabilize the cylinder block before work.• ...
Removal
SECURITY AND LOCKS > Rear Outer HandleREMOVAL1. Raise the glass assembly - rear door to the top position.2. Disconnect the ground cable from battery. NOTE">3. Remove the trim panel - rear door. Door Trim > REMOVAL">4. Remove the sealing cover - rear door. Rear Sealing Cover ...
SRS airbag system monitors
SRS airbag system warning light (type B)
A diagnostic system continually monitors
the readiness of the SRS airbag system
(including front seatbelt pretensioners)
while the vehicle is being driven. The
SRS airbag system warning light will show
normal system operation by illuminating
for ap ...
