Subaru Crosstrek Service Manual: Inspection

CAUTION:

Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.

1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.

2. Smoothness of rotation

Rotate the ball bearing while applying pressure in the thrust direction.

3. If noise or excessive play is noted, replace the pilot bearing.

Flywheel

Removal

Other materials:

Rear gate - if the rear gate cannot be opened
If the rear gate of your Subaru Ascent cannot be opened using the standard external button, it is possible to unlock it manually from inside the cargo area as an emergency measure. 1. Carefully remove the access panel located at the lower center of the rear gate trim. Use a flat-head scre ...

Throttle position sensor Specification
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle Position SensorSPECIFICATIONThrottle body is a non-disassembled part, so do not remove the throttle position sensor from throttle body.Refer to “Throttle Body” for removal and installation procedure. Throttle Body > REMOVAL"> ...

Removal
SECURITY AND LOCKS > Rear Outer HandleREMOVAL1. Raise the glass assembly - rear door to the top position.2. Disconnect the ground cable from battery. NOTE">3. Remove the trim panel - rear door. Door Trim > REMOVAL">4. Remove the sealing cover - rear door. Rear Sealing Cover ...