Subaru Crosstrek Service Manual: Removal
CLUTCH SYSTEM > Clutch Switch
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">
4. Remove the knee airbag module. Knee Airbag Module > REMOVAL">
5. Disconnect the connectors of the clutch switch and clutch start switch.
6. Remove the clutch switch and clutch start switch.
Adjustment
CLUTCH SYSTEM > Clutch SwitchADJUSTMENT1. Loosen the lock nut of the clutch start switch.(A)Lock nut(B)Clutch start switch2. Disconnect the harness connector of the clutch start switch.3. Remove th ...
Inspection
CLUTCH SYSTEM > Clutch SwitchINSPECTION1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clut ...
Other materials:
Dtc p0951 auto shift manual control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:Manual mode can not be set.CAUTION:Use the check board whe ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the ...
Inspection
STARTING/CHARGING SYSTEMS(H4DO) > Battery Current & Temperature SensorINSPECTION1. BATTERY CURRENT SENSORCAUTION:Pay attention to polarity when checking the resistance in the battery current sensor.Check the resistance between the battery current sensor terminals.Terminal No.Standard1 (+) and ...
