Subaru Crosstrek Service Manual: Relay and fuse
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
Location
Blind Spot Detection/Rear Cross Traffic Alert > Relay and Fuse
LOCATION
Fuse & Relay Box | Fuse 10 A (radar sensor LH (master), radar sensor RH (slave), BSD/RCTA OFF switch) | (A) |
NOTE:
For other related fuses, refer to the wiring diagram. Power Supply Circuit">
Radar sensor
Adjustment
Blind Spot Detection/Rear Cross Traffic Alert > Radar SensorADJUSTMENT1. RADAR AXIS ADJUSTMENTCAUTION:• After removal/installation or replacement of the radar sensor, perform the ...
Switches and harness
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Switches and HarnessINSPECTIONBSD/RCTA OFF switch1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTer ...
Other materials:
Dtc p0113 intake air temperature sensor 1 circuit high bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0113 INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT HIGH BANK 1DTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servicing o ...
Installation
EXHAUST(H4DO) > Center Exhaust PipeINSTALLATION1. Install the center exhaust pipe upper cover to the center exhaust pipe.Tightening torque:13 N·m (1.3 kgf-m, 9.6 ft-lb)2. Temporarily tighten the nuts which secure the center exhaust pipe to the front exhaust pipe.NOTE:Use a new gasket.3. In ...
Component
BRAKE > General DescriptionCOMPONENT1. FRONT DISC BRAKE(A)Shim-separate brake pad type(B)Shim-integrated brake pad type (1)Caliper body(11)Pad clip - upper(19)Cap - bleeder(2)Bleeder - screw(12)Pad clip - lower (3)Guide pin - front brake (black)(13)Shim - disc brake front*1:17 mm (width a ...
