Subaru Crosstrek Service Manual: Preparation tool
POWER ASSISTED SYSTEM (POWER STEERING) > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
34099PA100
SPANNER
Used when measuring the rotational resistance of gearbox assembly.
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Steering wheel puller | Used for removing the steering wheel. |
Circuit tester | Used for measuring resistance, voltage and current. |
DST-i | Used together with Subaru Select Monitor 4. |
C-clamp | Used when inspecting steering gearbox assembly. |
Component
POWER ASSISTED SYSTEM (POWER STEERING) > General DescriptionCOMPONENT1. STEERING WHEEL AND COLUMN(1)Bushing(7)Cover - steering wheel LWR(13)Airbag module(2)Column ASSY - steering(8)MID switch (3)S ...
Other materials:
Fuses
CAUTION
Never replace a fuse with one having
a higher rating or with material
other than a fuse because serious
damage or a fire could result.
The fuses are designed to melt during an
overload to prevent damage to the wiring
harness and electrical equipment. The
fuses are located in two fuse ...
Dtc p0031 a/f / o2 heater control circuit low bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0031 A/F / O2 HEATER CONTROL CIRCUIT LOW BANK 1 SENSOR 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...
Disassembly
FRONT SUSPENSION > Front ArmDISASSEMBLY1. BUSHING FRONT - FRONT ARM1. Put an alignment mark on the front arm assembly based on the split portion of the bushing intermediate plate of the busing front - front arm.CAUTION:Always put an alignment mark for aligning the position on bushing installation ...
