Subaru Crosstrek Service Manual: Operation

If the EyeSight pause code is detected from the stereo camera, all the functions of the EyeSight excluding the conventional cruise control stop temporarily and cannot be used. When the failure is resolved, the function starts operating.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «EyeSight» and select «Enter».

5. On «Select Function» display, select «Cancel Code».

6. On «Cancel Code» display, select «EyeSight Pause Code».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• Temporary stop is not released even if the lane departure warning OFF switch or pre-collision brake OFF switch is pressed.

• Depending on the situation, temporary stop may not be released even if the ignition switch is turned off.

• Up to 20 codes can be stored.

• Stored codes will be cleared by Clear Memory.

• For details on EyeSight temporary stop codes, refer to List of EyeSight temporary stop code. EyeSight Temporary Code(s) Display > LIST">

List

Freeze frame data display

Other materials:

Clear memory mode Operation
ENGINE (DIAGNOSTICS)(H4DO) > Clear Memory ModeOPERATION1. SUBARU SELECT MONITORNOTE:• Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.• For detailed ope ...

Turn signal lever
Right turn Lane change right signal Lane change left signal Left turn The turn signal lever in the Subaru Ascent is designed for precise and intuitive operation, allowing the driver to clearly communicate intended driving maneuvers to surrounding traffic. By moving the lever upwa ...

List of diagnostic trouble code (dtc) List
ENGINE (DIAGNOSTICS)(H4DO) > List of Diagnostic Trouble Code (DTC)LISTDTCItemNoteB1570ANTENNA Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1570 ANTENNA">B1571REFERENCE CODE INCOMPATIBILITY (IMMOBILIZER CM TO ECM) Diagnostic Procedure with Diagnostic Trouble Code (DTC) ...