Subaru Crosstrek Service Manual: Location
ENTERTAINMENT > Relay and Fuse
LOCATION
Relay & fuse box | Fuse 20 A (rear accessory power supply socket) | (A) |
Fuse 10 A (front accessory power supply socket) | (B) | |
Fuse 10 A (audio, navigation unit, AUX input terminal, data communication module*1) | (C) | |
Fuse 15 A (data communication module*1) | (D) |
*1: Model with telematics
NOTE:
For other related fuses, refer to the wiring diagram. Power Supply Circuit">
Inspection
ENTERTAINMENT > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring h ...
Other materials:
Assembly
CLUTCH SYSTEM > Master CylinderASSEMBLY1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.Grease:SILICONE GREASE G-40M or equivalent2. Assemble in the reverse order of disassembly.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb) ...
Battery
WARNING
Before beginning work on or near
any battery, be sure to extinguish
all cigarettes, matches, and lighters.
Never expose a battery to an
open flame or electric sparks.
Batteries give off a gas which is
highly flammable and explosive.
For safety, in case an explosion
do ...
Disassembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the rear hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the rear h ...
