Subaru Crosstrek Service Manual: List
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > User Customizing
LIST
• Combination meter (models with normal meters)
Items to be displayed | Initial setting value | Customize setting | Note |
Air temperature correction | ±0°C | −5°C — +5°C | Temperature compensation can only be performed by 1°C (1°C change = 1.8°F) interval. |
Mean fuel efficiency correction | ±0°% | +10% — −10% | — |
• Combination meter (models with color TFT)
Items to be displayed | Initial setting value | Customize setting | Note |
Air temperature correction | ±0°C | −5°C — +5°C | Temperature compensation can only be performed by 1°C (1°C change = 1.8°F) interval. |
Mean fuel efficiency correction | ±0°% | +10% — −10% | — |
Second level belt warning customize | 2-stage warning implemented | 2-stage warning implemented/2-stage warning not implemented | — |
Demonstration mode permission / fault permission | OFF | OFF/ON | Demonstration mode must not be permitted when used by a customer. |
User customizing
...
Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > User CustomizingOPERATION1. COMBINATION METER1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle ...
Other materials:
Assembly
DRIVE SHAFT SYSTEM > Rear AxleASSEMBLY1. BUSHING - REAR AXLE HOUSINGDo not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.2. REAR BUSHING1. Before assembly, inspect the following items and replace any fau ...
Parking brake
To set the parking brake, depress the
brake pedal firmly and hold it down until
the parking brake lever is fully pulled up.
To release the parking brake, pull the lever
up slightly, press the release button, then
lower the lever while keeping the button
pressed.
When the parking brake i ...
Dtc b2a0a red led circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0A RED LED CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:• Current in LED is less than 1 mA. (Improper LED connection, etc.)• Current is more than 200 mA for at le ...
