Subaru Crosstrek Service Manual: List
EyeSight (DIAGNOSTICS) > Freeze Frame Data Display
LIST
• List of freeze frame data
Display | Content | Unit |
ECU Power Supply Voltage (IG) | Display of input voltage of stereo camera | V |
Engine Speed | Engine speed | rpm |
Accel opening angle | Acceleration opening angle signal | % |
Brake Fluid Target Pressure | Target value of brake fluid pressure | MPa |
Master Cylinder Actual Fluid Pressure | Brake pressure | MPa |
Right Front Wheel W/C Actual Fluid Pressure | Right front wheel cylinder fluid pressure | MPa |
Left Front Wheel W/C Actual Fluid Pressure | Left front wheel cylinder fluid pressure | MPa |
Brake SW Input | Brake switch signal status | — |
Brake Lamp SW (BIU) | Brake light switch signal status | — |
Brake Lamp SW (VDC) | Brake light switch status | — |
Trip Count | Timestamp information_Trip counter | times |
Count | Timestamp information_original count identification information | — |
Time Count | Timestamp information_time counter | ms |
Drive Wheel Average Speed | Average wheel speed signal | km/h |
Brake Lamp Command | Brake lamp light up command signal | — |
Driver Brake Detection | Driver brake detection signal | — |
Brake Control Actuation | Brake operation permission signal | — |
Pre-Collision Brake Assist Command | Pre-collision brake assist command signal | — |
Pre-Collision Brake Action | Pre-collision brake command signal | — |
Adaptive Cruise Control Torque Down | Torque down prohibition signal of stereo camera | — |
Engine Failure | Engine failure signal | — |
Brake Lamp SW Fail Status | Brake light switch failure signal | — |
Operation
EyeSight (DIAGNOSTICS) > Freeze Frame Data DisplayOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confi ...
Other materials:
Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle's alarm system for
deactivation mode. Ref ...
Clear memory mode Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» ...
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
