EyeSight (DIAGNOSTICS) > Freeze Frame Data Display
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «EyeSight» and select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «FFD».
NOTE:
• For detailed operation procedures, refer to “Application help”.
• Freeze frame data is stored for three DTCs. Allocation of the three DTCs are as follows:
– DTC that occurred first.
– DTC that occurred first during the latest driving cycle (from IGN ON to IGN OFF).
– DTC that occurred first during the second latest driving cycle.
– However, DTCs will be stored in order of occurrence until these three DTCs are stored.
• For details on freeze frame data, refer to List of freeze frame data. Freeze Frame Data Display > LIST">
• Freeze frame data is cleared in Clear Memory Mode. Clear Memory Mode">
ListUser customizing Operation
BODY CONTROL SYSTEM (DIAGNOSTICS) > User CustomizingOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select ...
Dtc p0024 "b" camshaft position - timing over-advanced or system performance bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0024 "B" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine sta ...
General diagnostic table Inspection
CLUTCH SYSTEM > General Diagnostic TableINSPECTION1. CLUTCHSymptomsPossible causeCorrective action1. Clutch slippageIt is hard to perceive clutch slippage in the early stage, but pay attention to the following symptoms.• Engine temporarily speeds up when the accelerator ON immediately after ...