Subaru Crosstrek Service Manual: Installation

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• When installing the curtain airbag module, install a specified part at specified place.

• Be careful not to damage the curtain airbag module during installation.

• Never open the curtain airbag module before activation. Never reuse the deployed curtain airbag module.

• Make sure that there are no foreign matter on airbag module.

• When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.

• For installation of the stereo camera cover, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION">

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Airbag cover is scratched or torn.

• Harness and/or connector is cracked, deformed or open.

• Harness wire is exposed.

• Mounting bracket and securing clip are cracked or deformed.

2. Install the curtain airbag module.

CAUTION:

• Be sure to insert the connector in until it is locked.

• Press in the push lock securely. Then pull it gently to make sure that it is locked.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

3. Install the remaining parts in the reverse order of removal.

Curtain airbag module

Removal

Other materials:

Roof tent
WARNING Installing a roof tent on the Subaru Ascent increases the overall weight positioned above the vehicle’s center of gravity, which can negatively influence handling, braking efficiency, and rollover resistance. Under no circumstances should the Subaru Ascent be driven if the total ...

Preparation tool
CLUTCH SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS498497100CRANKSHAFT STOPPERUsed for stopping rotation of the flywheel.499747100CLUTCH DISC GUIDEUsed for installing the clutch disc to the flywheel. — SUBARU SELECT MONITOR 4Used for setti ...

Electrical specification
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONNOTE:The terminal numbers of the power steering control module connectors are as indicated in the figure.ContentsTerminal No.Input/output signalMeasured value and measuring conditionsPower supp ...