Subaru Crosstrek Service Manual: Installation

CAUTION:

Do not reuse the bolt and nut.

Always use new bolts and nuts for them.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Control module is deformed.

• Control module connector is damaged.

• Control module mounting bracket is damaged.

2. Install each part in the reverse order of removal.

Tightening torque:

Airbag control module: 25 N·m (2.55 kgf-m, 18.4 ft-lb)

Console box assembly: 6.5 N·m (0.66 kgf-m, 4.8 ft-lb)

Airbag control module

Removal

Other materials:

Removal
LIGHTING SYSTEM > Rear Side Marker Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...

Gross Axle Weight (GAW) and Gross Axle Weight Rating (GAWR)
Gross Axle Weight The total weight applied to each axle (GAW) must never exceed the Gross Axle Weight Rating (GAWR). The front and rear GAWs can be adjusted by relocating passengers and luggage inside the vehicle. The front and rear GAWR of your vehicle that is given by SUBARU are also ...

Dtc b1818 short in passenger s airbag dual stage - 2nd step circuit (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1818 SHORT IN PASSENGER’S AIRBAG DUAL STAGE - 2ND STEP CIRCUIT (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to power supply.• ...