WIPER AND WASHER SYSTEMS > Rear Wiper Motor
INSTALLATION
1. Install each part in the reverse order of removal.
2. Check that the mark on the cap - pivot wiper faces up, as shown in the figure.

Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
Removal
Relay and fuseHandling of radar sensors
Sensors
In the Subaru Ascent, radar sensors are strategically positioned on both sides
of the rear bumper to monitor adjacent traffic and support BSD/RCTA functionality.
To maintain reliable and accurate operation of the Subaru Ascent BSD/RCTA system,
the following precautions must al ...
Open/close
To open:
First unlock the rear gate lock then push
the rear gate opener button.
To close:
Lower the rear gate slowly and push down firmly until the latch engages.
The rear gate can be lowered easily if you
pull it down holding the recessed grip.
WARNING
To prevent dangerous exhaust
...
Dtc b2a0c dcm internal fault
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0C DCM INTERNAL FAULTDIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:• Main microcomputer and communication circuit IC cannot communicate. (Defective IPC)• SIM ...