Subaru Crosstrek Service Manual: Installation
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD)
INSTALLATION
CAUTION:
• Make sure the electrical connector is connected securely.
• Make sure that the multi-function display (MFD) operates normally.
• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.
• When the multi-function display has been replaced, perform the following operations.
– Be sure to reset the ODO fuel economy value of the multi-function display (MFD). (High grade type) Multi-function Display (MFD) System > OPERATION">
– Be sure to correction the lifetime fuel economy value of the multi-function display (MFD). (High grade type) Multi-function Display (MFD) System > OPERATION">
Install each part in the reverse order of removal.
Removal
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD)REMOVAL1. MULTI FUNCTION DISPLAY1. Disconnect the ground cable from battery. NOTE">2. Remove the center grille assembly. Air Vent ...
Other materials:
Welcome lighting function (if
equipped)
The welcome lighting function turns on the
low beam headlight for smooth approaching
to or exiting from the vehicle at night or
in a dark place.
The function is activated while all of the
following conditions are met.
The light control switch is in the
"AUTO" position
It is dark enoug ...
Electrical specification
CONTROL SYSTEMS > AT Shift Lock Control SystemELECTRICAL SPECIFICATION• Model without push button ignition switchItemConnector No.Terminal No.Input/Output signalMeasured value and measuring conditionsBattery power supplyB28169 — 16 V7i846Ignition power supplyB2803210 — 15 V when ignitio ...
Component
COMMUNICATION SYSTEM > General DescriptionCOMPONENT(1)Horn switch (driver’s airbag module ASSY)(3)Horn relay(5)Horn ASSY - Hi(2)Roll connector(4)Horn ASSY - Lo ...
