Subaru Crosstrek Service Manual: Installation

CAUTION:

• If the hose and pipe have been replaced, add an appropriate amount of compressor oil to the compressor. Compressor Oil > ADJUSTMENT">

• Replace the O-rings with new parts, and then apply compressor oil.

• When connecting hoses and pipes, do not apply excessive force. After installing, check that no torsion or excessive tension applied to the hoses.

1. Install each part in the reverse order of removal.

Tightening torque:

Air conditioning unit: General Description > COMPONENT">

2. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE">

Removal

In-vehicle sensor (auto a/c model)

Other materials:

Dtc u0422 invalid data received from body control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULEReceived error data from BIU.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

Wheel bearing Inspection
PERIODIC MAINTENANCE SERVICES > Wheel BearingINSPECTION1. FRONT WHEEL BEARINGNOTE:Inspect the condition of front wheel bearing grease.1. Jack-up the front side of vehicle.2. While holding the front wheel by hand, swing it in and out to check bearing free play.3. Loosen the wheel nuts, and remove ...

Removal
SECURITY AND LOCKS > Front Hood Lock AssemblyREMOVAL1. Open the front hood.2. Remove the clip, and remove the bracket - grille.NOTE:To prevent damage to the bracket - grille, make sure to remove all clips.3. Remove the lock assembly - front hood.(1) Remove the bolt and clip.(2) Disconnect the rel ...