EXTERIOR/INTERIOR TRIM > Front Under Cover
INSTALLATION
CAUTION:
Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).

Install each part in the reverse order of removal.
Tightening torque:
18 N·m (1.84 kgf-m, 13.3 ft-lb)
RemovalAlarm system
The Subaru Ascent is equipped with a comprehensive alarm system designed to protect
the vehicle and its contents from unauthorized access or theft attempts.
If an intrusion is detected, the Subaru Ascent alarm system activates both audible
and visual warnings, including the horn and hazard warn ...
Hill start assist system
Ensure that the Hill start assist system
operates properly under the following
circumstances.
1. Stop the vehicle on an uphill grade by
depressing the brake pedal (all models)
and clutch pedal (MT models only), with
the engine running.
2. Make sure that the vehicle does not
move backward ...
Removal
EXTERIOR/INTERIOR TRIM > Door TrimREMOVAL1. FRONT DOOR1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - front door.(1) Attach the protective tape (a).(2) Open the cover and remove the screw.(3) Remove the clips, and remove the trim panel - front door from the ...