Subaru Crosstrek Service Manual: Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Fuel Sub Level Sensor
INSTALLATION
For installation procedures, refer to the “FU (H4DO)” section. Fuel Sub Level Sensor > INSTALLATION">
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Fuel Sub Level SensorREMOVALFor removal procedures, refer to the “FU (H4DO)” section. Fuel Sub Level Sensor > REMOVAL"& ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSPECTION1. MAGNET CLUTCH CLEARANCE INSPECTION1. Check the clearance of entire circumference around the drive plate and pulley.Specification:0.3 — 0.6 mm (0.0118 — 0.0236 in)2. Replace the compressor assembly if the inspection result is no ...
Inspection
EyeSight > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsS ...
Installation
SEATS > Rear SeatINSTALLATIONInstall each part in the reverse order of removal.NOTE:• After installing the backrest assembly, make sure that each seat belt operates normally.• Make sure that they are properly secured on each hook on the vehicle side.Tightening torque:Refer to “C ...
