Subaru Crosstrek Service Manual: Removal

For removal procedures, refer to the “FU (H4DO)” section. Fuel Sub Level Sensor > REMOVAL">

Inspection

Installation

Other materials:

System maintenance
NOTE For models without "keyless access with push-button start system": In the event that the vehicle's battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remote engine start system. This is r ...

Switches and harness
Inspection Blind Spot Detection/Rear Cross Traffic Alert > Switches and HarnessINSPECTIONBSD/RCTA OFF switch1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply ba ...

Starter motor circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureSTARTER MOTOR CIRCUIT1. MODEL WITHOUT PUSH BUTTON STARTCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode">, and Inspection Mode Inspection Mode">.Wiring diagram:Engin ...