Subaru Crosstrek Service Manual: Installation
DIFFERENTIALS > Rear Differential (VA-type)
INSTALLATION
The installation procedure for VA1-type is included in “INSTALLATION” for T-type. Rear Differential (T-type) > INSTALLATION">
Inspection
DIFFERENTIALS > Rear Differential (VA-type)INSPECTIONWash all the disassembled parts clean, and examine them for wear, damage or other defects. Repair or replace the defective parts as necessary.1. ...
Removal
DIFFERENTIALS > Rear Differential (VA-type)REMOVALThe removal procedure for VA1-type is included in “REMOVAL” for T-type. Rear Differential (T-type) > REMOVAL"> ...
Other materials:
Removal
SECURITY AND LOCKS > Starter Cut RelayREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait fo ...
Note
VEHICLE DYNAMICS CONTROL (VDC) > Vehicle Dynamics Control SystemNOTEFor operation procedures of each component of the vehicle dynamics control system, refer to the respective section.• VDC control module & hydraulic control unit (VDCCM&H/U): VDC Control Module and Hydraulic Control ...
Installation
MECHANICAL(H4DO) > Cylinder BlockINSTALLATION1. Apply engine oil to the crankshaft bearing, and install the crankshaft bearing to the cylinder block.CAUTION:• Place a wood board wrapped with a waste cloth to prevent the knock pin damage and to stabilize the cylinder block before work.• ...
