Subaru Crosstrek Service Manual: Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
2. CHECK RELAY
1. Check the resistance between relay terminals.
• A/C relay
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 2
Apply battery voltage between terminals 4 and 3.
Less than 1 ?
• Blower motor relay
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 4 | Always | 1 M? or more |
1 — 4
Apply battery voltage between terminals 2 and 3.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard.
Relay and fuse
...
Location
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Relay and FuseLOCATIONMain fuse boxA/C relay(A)Relay & fuse boxFuse 15 A (blower motor relay)(B)Fuse 15 A (blower motor relay)(C)Fuse 7.5 A (A/C contr ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSPECTION1. MANUAL A/C MODELWIRING DIAGRAM:1. Prepare the vehicle.NOTE:Check that the ambient temperature is 25 — 40°C (77 — 104°F) and that the humidity is 30% — 80%.• Place the vehicle in the workshop ...
Inspection
PARKING BRAKE > Parking Brake Assembly (Rear Disc Brake)INSPECTION1. Measure the inner diameter of the rear disc rotor. If scoring or worn is found on the disc, replace the rear disc rotor.Disc rotor inner diameter:Specification: 170 mm (6.69 in)Service limit: 171 mm (6.73 in)2. Measure the linin ...
Rear wiring harness and rear gate cord Location
WIRING SYSTEM > Rear Wiring Harness and Rear Gate CordLOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionR163C-4 Rear door switch RHR223C-2 Rear door switch LHR2510BlackC-2 Radar sensor LH (master)R266GrayC-5 Rear combination light RHR286GrayC-3 Rear combination light LHR293BlackD-2 Rear ...
