HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Vent Grille
INSPECTION
1. Check that the direction and amount of air can be adjusted smoothly. Replace the grille assembly - ventilation if faulty.
2. Check that the adjustment can be maintained in each position. Replace the grille assembly - ventilation if faulty.
Air vent grille
RemovalInstallation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...
Power window operation by passengers
Passenger's side power window switches
Each passenger window can be controlled
by the power window switch located on
the door.
Operating the windows
To open:
Press the switch down and hold it until the
window reaches the desired position.
To close:
Pull the switch up and hold it u ...
Preparation tool
LIGHTING SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to “A ...