Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Continuously variable transmission(tr580) / Transmission harness / Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Harness

INSPECTION

1. Visually check the harness and connector for damage or crack.

2. Check the harness terminal for rust, disconnection or poor contact.

3. Check the continuity between harness terminals.

NOTE:

For details of transmission harness circuit, refer to wiring diagram. CVT Control System > WIRING DIAGRAM">

Harness continuity standard

Less than 1 ?

Removal

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission HarnessREMOVAL1. INHIBITOR HARNESS1. Remove the transmission from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Rem ...

Other materials:

Dtc c0051 valve relay
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0051 VALVE RELAYDTC detecting condition:Defective valve relayTrouble symptom:• ABS does not operate.• EBD does not operate.• VDC does not operate.• EyeSight does not ...

Inspection
SECURITY AND LOCKS > Steering Lock CMINSPECTION1. Check if the steering lock is released when you start the engine using the push button ignition switch.2. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS AC ...

Disassembly
REAR SUSPENSION > Rear Trailing LinkDISASSEMBLY1. BUSHING A - TRAILING LINKUsing the ST, push out the bushing A - trailing link.Preparation tool:ST-A: INSTALLER (899874100)ST-B: INSTALLER & REMOVER (BASE) (20099PA010)2. BUSHING - TRAILING LINKFor the removal procedure of bushing - trailing li ...