Subaru Crosstrek Owners Manual: Ignition switch light (if equipped)
For easy access to the ignition switch in the dark, the ignition switch light illuminates when the driver's door is opened or when the driver's door is unlocked using the remote keyless entry transmitter.
The light remains illuminated for several tens of seconds and then gradually turns off under the following conditions.
- when the driver's door is closed
- when the doors are unlocked using the remote keyless entry transmitter
The light turns off immediately under the following conditions.
- when the ignition switch is turned to the "ON" position
- when all doors and the rear gate are locked using the remote keyless entry transmitter
Key reminder chime
The reminder chime sounds when the
driver's door is opened and the ignition
switch is in the "LOCK" or "ACC" position.
The chime stops under the following
conditions.
when the ignition switc ...
Push-button ignition switch (models with push-button start system)
Safety precautions
Refer to "Safety precautions"2-10. ...
Other materials:
Control module i/o signal Electrical specification
BODY CONTROL SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONDescriptionTerminal No.Signal (V or ?)NoteIgnition switch ON(Engine OFF)Ignition power supply (rear wiper)A5 ←> Chassis groundLess than 1.5 V > 10 — 13 VIgnition switch OFF > ONBattery power suppl ...
Installation
MECHANICAL(H4DO) > Cylinder HeadINSTALLATION1. CYLINDER HEAD RH1. Clean the bolt holes in the cylinder block RH.CAUTION:To avoid erroneous tightening of the bolts, clean out the bolt holes sufficiently by blowing with compressed air to eliminate engine coolant etc.2. Apply liquid gasket to both s ...
Removal
EXTERIOR BODY PANELS > Front Sealing CoverREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the sealing cover - front door.CAUTION:• Caref ...
