Subaru Crosstrek Service Manual: Hill start assist warning light does not come on
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination Pattern
HILL START ASSIST WARNING LIGHT DOES NOT COME ON
Detecting condition:
Defective combination meter
Trouble symptom:
When the ignition switch is turned to ON (engine OFF), hill start assist warning light does not illuminate.
| STEP | CHECK | YES | NO |
1.CHECK OTHER INDICATOR LIGHT.
Turn the ignition switch to ON. (Engine OFF)
Do other indicator lights illuminate?
Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT COME ON">Go to Step 2.
Check the combination meter. Combination Meter System > OPERATION">
2.READ DTC.
Read the DTC. Read Diagnostic Trouble Code (DTC)">
Is DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT COME ON">Go to Step 3.
3.CHECK LAN SYSTEM.
Perform the diagnosis for LAN system. Basic Diagnostic Procedure">
Is there any fault in LAN system?
Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">
Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT COME ON">Go to Step 4.
4.CHECK COMBINATION METER.
Check the combination meter. Combination Meter System > OPERATION">
Is the check result OK?
• Models without EyeSight
Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">
• Models with EyeSight
Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">
Replace the combination meter. Combination Meter">
Brake warning light does not go off
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternBRAKE WARNING LIGHT DOES NOT GO OFFDetecting condition:• Brake warning light circuit is shorted.• Defect ...
Basic diagnostic procedure Procedure
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installat ...
Other materials:
Entering the vehicle while it is running via remote start (models without "keyless
access with push-button start system")
1. Unlock the Subaru Ascent using the remote keyless entry system.
NOTE
If the Subaru Ascent is unlocked manually with a physical key while the alarm
system is armed, the alarm will activate and the engine will stop. To deactivate
the alarm, perform one of the following actions.
Insert the ...
Installation
PARKING BRAKE > Parking Brake LeverINSTALLATION1. Install each part in the reverse order of removal.CAUTION:• The front seat mounting bolts differ between the front mounting points and the rear mounting points. When installing the front seat, make sure that you are using correct bolts at co ...
Dtc u0100 lost communication with ecm/pcm a
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”DTC DETECTING CONDITION:No data is received from ECM.TROUBLE SYMPTOM:Cooperation control of transmission may not operate properly.STEPCHECKYESNO1.CHECK PERFOR ...
