Subaru Crosstrek Service Manual: General diagnostic table Inspection
WHEEL AND TIRE SYSTEM > General Diagnostic Table
INSPECTION
Symptoms | Possible cause | Corrective action |
Wheel is out of balance. | Improperly inflated tire. | Adjust the tire pressure. |
Uneven wear | Check the tire referring to “Abnormal tire wear” in this table, carry out the procedure and replace the tire. | |
Front wheel alignment | Check or adjust the front wheel alignment. |
• Inspection: Wheel Alignment > INSPECTION">
• Adjustment: Wheel Alignment > ADJUSTMENT">
Rear wheel alignment
Check or adjust the rear wheel alignment.
• Inspection: Wheel Alignment > INSPECTION">
• Adjustment: Wheel Alignment > ADJUSTMENT">
Front strut
Check the front strut. Front Strut > INSPECTION">
Rear shock absorber
Check the rear shock absorber. Rear Shock Absorber > INSPECTION">
Housing ASSY - front axle
Check the housing assembly - front axle. Front Hub Unit Bearing > INSPECTION">
Hub unit COMPL - front axle
Check the hub unit COMPL - front axle. Front Hub Unit Bearing > INSPECTION">
Hub unit COMPL - rear axle
Check the hub unit COMPL - rear axle. Rear Hub Unit Bearing > INSPECTION">
Vehicle is abnormally out of balance.
Improperly inflated tire.
Adjust the tire pressure.
Uneven wear
Check the tire referring to “Abnormal tire wear” in this table, carry out the procedure and replace the tire.
Front stabilizer
Inspect the front stabilizer.
Front wheel alignment
Check or adjust the front wheel alignment.
• Inspection: Wheel Alignment > INSPECTION">
• Adjustment: Wheel Alignment > ADJUSTMENT">
Rear wheel alignment
Check or adjust the rear wheel alignment.
• Inspection: Wheel Alignment > INSPECTION">
• Adjustment: Wheel Alignment > ADJUSTMENT">
Abnormal wheel vibration
Improperly inflated tire.
Adjust the tire pressure.
Uneven wear
Check the tire referring to “Abnormal tire wear” in this table, carry out the procedure and replace the tire.
Improper wheel balancing
Check the wheel balance. Tire and Wheel > INSPECTION">
Housing ASSY - front axle
Check the housing assembly - front axle. Front Hub Unit Bearing > INSPECTION">
Hub unit COMPL - front axle
Check the hub unit COMPL - front axle. Front Hub Unit Bearing > INSPECTION">
Hub unit COMPL - rear axle
Check the hub unit COMPL - rear axle. Rear Hub Unit Bearing > INSPECTION">
Abnormal tire wear
Improperly inflated tire.
Adjust the tire pressure.
Improper wheel balancing
Check the wheel balance. Tire and Wheel > INSPECTION">
Front wheel alignment
Check or adjust the front wheel alignment.
• Inspection: Wheel Alignment > INSPECTION">
• Adjustment: Wheel Alignment > ADJUSTMENT">
Rear wheel alignment
Check or adjust the rear wheel alignment.
• Inspection: Wheel Alignment > INSPECTION">
• Adjustment: Wheel Alignment > ADJUSTMENT">
Installation
WHEEL AND TIRE SYSTEM > Tire Pressure Monitoring SystemINSTALLATION1. TRANSMITTER (TIRE INFLATION PRESSURE SENSOR)CAUTION:Use the new transmitter assembly or replace the new valve and screw, when i ...
Other materials:
Initialize
Items that have been set to your preference
can be initialized. To select an
initialization menu, operate the "
" or " "
switch as follows.
Preparation for initialization
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to show
the selection screen.
3. ...
Replacement
SECURITY AND LOCKS > Keyless TransmitterREPLACEMENT1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITORNOTE:• A maximum of four keyless transmitters can be registered for each individual vehicle.• When replacing or adding the keyless transmitter, new registration of trans ...
Dtc u0073 control module communication bus off
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
