Subaru Crosstrek Service Manual: Front stabilizer

Removal

FRONT SUSPENSION > Front Crossmember Support PlateREMOVAL1. Lift up the vehicle.2. Remove the under cover - front. Front Under Cover > REMOVAL">3. Remove the bolt, and remove the front ...

Installation

FRONT SUSPENSION > Front StabilizerINSTALLATION1. Before installation, inspect the following items and replace any faulty part with a new one.• Check the bushing - stabilizer for abnormal cra ...

Other materials:

Dtc u0428 invalid data received from steering angle sensor module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0428 INVALID DATA RECEIVED FROM STEERING ANGLE SENSOR MODULEDTC DETECTING CONDITION:Defective data was transmitted from steering angle sensor.TROUBLE SYMPTOM:VDC CM does not operate normally.STEPCHECKYESNO1.CHE ...

Preparation for car settings
1. Turn the ignition switch to the "ON" position. 2. Push and hold the button to show the selection screen. 3. After the selection screen is displayed, operate the " " or " " switch to show the "Car Setting" item. Then, push the button. ...

Dtc p2096 post catalyst fuel trim system too lean bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2096 POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...