Subaru Crosstrek Owners Manual: Engine oil
For the checking, adding and replacing procedure or other details, refer to "Engine oil" F11-8.
NOTE
The procedure for changing the engine oil and oil filter should be performed by a properly-trained expert. It is recommended that you have this service performed by your SUBARU dealer.
Approved engine oil
Always use the SUBARU approved engine oil. For further details, please contact your SUBARU dealer.
If the approved engine oil is unavailable, use the alternative engine oil described on the next page.
Alternative engine oil
If the SUBARU approved oil is unavailable, the following alternative oil can be used.
NOTE
Each quantity indicated here is only a guideline. The necessary quantity for replacement may differ slightly depending on the temperature and other factors.
| Oil grade | SAE viscosity No. and applicable temperature | Engine oil capacity | ||
 API (American Petroleum Institute) classification SN with the words "RESOURCE CONSERVING" |
or |  ILSAC (International Lubricant Specification Advisory Committee) GF-5, which can be identified with the ILSAC certification mark (Starburst mark) |
0W-20 synthetic oil is the required oil
for optimum engine performance and
protection. Conventional oil may be
used if synthetic oil is unavailable.
*: If 0W-20 synthetic oil is not available,
5W-30 or 5W-40 conventional oil may
be used if replenishment is needed but
should be changed to 0W-20 synthetic
oil at the next oil change. |
Adding the oil from low level to
full level:
1.1 US qt (1.0 liter, 0.9 Imp qt) Changing the oil and oil filter: 5.1 US qt (4.8 liters, 4.2 Imp qt) |
Specifications
Dimensions
These specifications are subject to change without notice.
*: Measured with vehicle empty
Engine
Fuel
For more details, refer to "Fuel" F7-3. ...
Manual transmission, front differential and rear differential gear oil
*1: The indicated oil quantity is only a guideline. The necessary quantity
for replacement may differ slightly depending on the temperature and other
factors. After refilling the gearbox with o ...
Other materials:
Removal
PARKING BRAKE > Parking Brake LeverREMOVALCAUTION:Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION">1. Set the wheel stoppers to tires.2. Remove the headrest assembly - front.3. Move the pas ...
Assembly
CONTROL SYSTEMS > MT Gear Shift LeverASSEMBLYNOTE:• Clean all the parts before assembly.• Apply NIGTIGHT LYW No. 2 grease or equivalent to each part. General Description > COMPONENT">1. Mount the bushing and cushion rubber to the stay.(A)Bushing(B)Stay(C)Cushion rubber2. I ...
Dtc b1693 door sensor rh initialization incomplete
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1693 DOOR SENSOR RH INITIALIZATION INCOMPLETEDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Front door impact sensor (RH ...
