Subaru Crosstrek Service Manual: Electrical specification

For details on the input/output signals for the engine control module, refer to ENGINE (DIAGNOSTICS). Engine Control Module (ECM) I/O Signal > ELECTRICAL SPECIFICATION">

Engine control module (ecm) i/o signal

Wiring diagram

Other materials:

Assembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingASSEMBLY1. Install the rear hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)(1)Rear hub unit bearing2. Using a press, press new hub bolts (b) until their seating surfaces contact the rear hub unit bearing (a).NOTE:Use the 12 ...

Installation
EXTERIOR/INTERIOR TRIM > Roof SpoilerINSTALLATIONCAUTION:• Make sure that packings are attached on the clips of the roof spoiler assembly. If a gasket is not attached, water leakage may occur.• Make sure the bolt is tightened securely because improper installation may cause the water ...

Tire pressure warning light does not come on
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination PatternTIRE PRESSURE WARNING LIGHT DOES NOT COME ONDETECTING CONDITION:Defective combination meterTROUBLE SYMPTOM:When the ignition switch is turned to ON, the tire pressure warning ...