EXTERIOR/INTERIOR TRIM > Door Trim
DISASSEMBLY
1. Remove the door trim.
2. Remove the rivets and claws, and remove the weather strip - door INN from the door trim.

(a) | Rivet | (b) | Claw | (c) | Claw |
NOTE:
Remove the rivets by using the rivet cutter or nippers.
Removal
InstallationInspection
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AT OIL TEMP Warning Light DisplayINSPECTIONDIAGNOSIS:• CAN communication is lost with the combination meter.• Combination meter malfunction• TCM is in special control mode.• AT learning is not finished.TROUBLE SYMPTOM:&bul ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnection diagram4 — 3Approx. 0.43 ?4 — 2Approx. 1.03 ?4 — 1Approx. 3 ?2. Replace the resistor if the ...
Relay and fuse
Inspection
CRUISE CONTROL SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness. Location
CRUISE CONTROL SYSTEM > Relay and FuseLOCATIONRelay & f ...