CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U1235 LOST COMMUNICATION WITH EyeSight
NOTE:
Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
• Detect malfunction of CAN communication.
• Judge as NG when CAN communication failure occurs with the stereo camera.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
12 V battery system voltage | ≥ 10 V |
Measured turbine shaft speed | > 0 rpm |
or | |
Transmission range | Drive or Reverse |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
CAN data from stereo camera | Lost |
Time Needed for Diagnosis: 2 seconds
Malfunction Indicator Light Illumination: Does not illuminate.
Dtc u0073 control module communication bus offInstrument panel
Illumination brightness control
Vehicle Dynamics Control OFF switch
Combination meter
Information display (page 3-32)/Multi
function display
Hazard warning flasher switch (models
with multi function display)
Hazard warning flasher switch (models
without multi function display) ...
Dtc u0122 lost communication with vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data from VDC CM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Pro ...
Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Low tire pressure warning light (type A)
Low tire pressure warning light (type B)
The tire pressure monitoring system provides
the driver with the warning message
indicated by sending a signal from a
sensor that is installed in each wheel
when tire pressure is severely low.
The tire ...