Subaru Crosstrek Service Manual: Dtc p0604 internal control module random access memory (ram) error

Subaru Crosstrek Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p0604 internal control module random access memory (ram) error

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P0604 INTERNAL CONTROL MODULE RANDOM ACCESS MEMORY (RAM) ERROR

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM:

TCM RAM malfunction

STEP	CHECK	YES	NO

1.CHECK DTC.

1) Perform the Clear Memory Mode using the Subaru Select Monitor. Clear Memory Mode">

2) Read the DTC.

Is DTC P0604 displayed?

Replace the TCM. Transmission Control Module (TCM)">

Current condition is normal. Check for interference from noise, etc.

1. OUTLINE OF DIAGNOSIS

• Detect the malfunction in RAM area of the TCM.

• Judge as NG if an attempt to write to RAM area failed.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
12 V battery system voltage	≥ 10 V

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
Writing-check (RAM) NOTE:

Malfunction Criteria

Threshold Value

Writing-check (RAM)

NOTE:

This check is carried out about the RAM only used for CAN communication.

Error

Time Needed for Diagnosis: Immediately

Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.

Dtc p0500 vehicle speed sensor "a" circuit

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0500 VEHICLE SPEED SENSOR "A" CIRCUITDTC DETECTING CONDITION:Immediately at ...

Dtc p062f internal control module eeprom error

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P062F INTERNAL CONTROL MODULE EEPROM ERRORDTC DETECTING CONDITION:Detected when two con ...

Other materials:

Communication for initializing impossible
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Subaru Select MonitorCOMMUNICATION FOR INITIALIZING IMPOSSIBLENOTE:Confirm that the LAN system is working properly before the diagnosis.Subaru Select Monitor communication line is open or shorted.Detecting condition:• Defective ha ...

Average vehicle speed
U.S.-spec. models Except U.S.-spec. models This display shows the average vehicle speed since the trip meter was last reset. Trip knob Pressing the trip knob toggles the display between the average vehicle speed corresponding to the A trip meter display and the average veh ...

Charge
STARTING/CHARGING SYSTEMS(H4DO) > BatteryCHARGEWARNING:• Do not bring an open flame close to the battery when working.CAUTION:• Prior to charging, corroded terminals should be cleaned with a brush and common caustic soda solution.• Be careful while charging the battery because i ...