Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc p0346 camshaft position sensor "a" circuit range/performance bank 2

Subaru Crosstrek Service Manual / Engine (diagnostics)(h4do) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p0346 camshaft position sensor "a" circuit range/performance bank 2

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P0346 CAMSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCE BANK 2

NOTE:

For the diagnostic procedure, refer to DTC P0345. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0345 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 2">

1. OUTLINE OF DIAGNOSIS

NOTE:

For the detection standard, refer to DTC P0341. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0341 CAMSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCE BANK 1 OR SINGLE SENSOR">

Dtc p0345 camshaft position sensor "a" circuit bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0345 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 2DTC DETECTING CONDITION:Immediately at fault recog ...

Dtc p0351 ignition coil "a" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0351 IGNITION COIL "A" PRIMARY CONTROL CIRCUIT/OPENDTC detecting condition:Immediately at fault re ...

Other materials:

Airflow mode selection
To select the airflow mode: Type A, B and C: Turn the airflow mode selection dial. Type D: Press the airflow mode selection button. To select the defrost mode: Type A and B: Turn the airflow mode selection dial. Type C and D: Press the defroster button. Airflow modes are as follows. ...

Preparation tool
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor ...

Inspection
BRAKE > Brake PedalINSPECTION1. Move the pad - brake pedal in a horizontal direction with a force of approx. 10 N (1 kgf, 2 lbf), and check that the pedal deflection is in the range of specifications.CAUTION:If excessive deflection is noted, replace with a new bushing.Deflection of brake pedal:We ...

© 2016-2026 Copyright www.sucross.com