Subaru Crosstrek Service Manual: Dtc c0044 tcm communication circuit

DTC detecting condition:

No CAN signal from TCM.

Trouble symptom:

• ABS does not operate.

• VDC does not operate.

• EyeSight does not operate.

1.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is there any fault in LAN system?

Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 2.

2.CHECK POOR CONTACT OF CONNECTORS.

Is there poor contact of TCM connector?

Repair the connector.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 3.

3.CHECK TCM.

Refer to the basic diagnostic procedure for Transmission (diagnostics).

Is the check result OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 4.

Replace the TCM. Transmission Control Module (TCM)">

4.CHECK VDCCM&H/U.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Perform the Inspection Mode. Inspection Mode">

3) Read the DTC. Read Diagnostic Trouble Code (DTC)">

Is the same DTC displayed?

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 5.

5.CHECK DETECTION OF OTHER DTCS FOR VDC.

Read Diagnostic Trouble Code (DTC)">

Is any other DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.

Dtc c0042 power supply voltage failure

Dtc c0047 can communication

Other materials:

Dtc u0416 invalid data received from vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULEReceived error data from VDC CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROC ...

Dtc p0705 transmission range sensor "a" circuit (prndl input)
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0705 TRANSMISSION RANGE SENSOR "A" CIRCUIT (PRNDL INPUT)DTC detecting condition:Immediately at fault recognitionTrouble symptom:• Shift characteristics are erroneous.&bul ...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Mounting SystemREMOVAL1. PITCHING STOPPER1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.2. Remove the clip (A) from the air intake boot.3. L ...