Subaru Crosstrek Service Manual: Dtc b28af stereo camera adjustment incomplete
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B28AF STEREO CAMERA ADJUSTMENT INCOMPLETE
Detected when adjustment or inspection of stereo camera has not been completed normally.
DTC DETECTING CONDITION:
• Operation is aborted during adjustment or inspection of the stereo camera.
• After the replacement of the stereo camera, adjustment or inspection of camera has not yet been performed.
TROUBLE SYMPTOM:
All functions of EyeSight system do not operate.
For diagnostic procedure, perform adjustment/inspection of camera. When the adjustment or inspection of camera is performed, and if it is not completed successfully, replace the camera.
Dtc b28ae internal stereo camera power supply
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28AE INTERNAL STEREO CAMERA POWER SUPPLYDetected when improper power supply inside the stereo camera occurs.DTC ...
Dtc b28b1 stereo camera automatic adjustment
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28B1 STEREO CAMERA AUTOMATIC ADJUSTMENTDetected when the optical axis of stereo camera is deviated in lateral di ...
Other materials:
Open/close
To open:
First unlock the rear gate lock then push
the rear gate opener button.
To close:
Lower the rear gate slowly and push down firmly until the latch engages.
The rear gate can be lowered easily if you
pull it down holding the recessed grip.
WARNING
To prevent dangerous exhaust
...
Front seats
WARNING
Never adjust the seat while driving
to avoid loss of vehicle control
and personal injury.
Before adjusting the seat, make
sure the hands and feet of rear
seat passengers and cargo are
clear of the adjusting mechanism.
After adjusting the seat, push it
slightly to make sur ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSTALLATIONCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.Install in the reverse order of removal.NOTE:• Use new O-rings.&bul ...
