Subaru Crosstrek Service Manual: Dtc b16f8 satellite safing sensor recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code
DTC B16F8 SATELLITE SAFING SENSOR RECOGNITION ERROR
Diagnosis start condition:
Ignition voltage is 10 V to 16 V.
DTC detecting condition:
• Satellite safing sensor is misinstalled.
• Airbag control module is faulty.
| STEP | CHECK | YES | NO |
1.REPLACE SATELLITE SAFING SENSOR.
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.
2) Replace the satellite safing sensor with a genuine sensor. Satellite Safing Sensor > REMOVAL">
Does the warning light go off?
Finish the diagnosis.
Replace the airbag control module. Airbag Control Module > REMOVAL">
Dtc b1677 satellite safing sensor initialization incomplete
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1677 SATELLITE SAFING SENSOR INITIALIZATION INCOMPLETEDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting c ...
Dtc b16f9 door sensor rh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F9 DOOR SENSOR RH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• ...
Other materials:
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential AssemblyDISASSEMBLY1. DIFFERENTIAL CASE ASSEMBLY1. Remove the twelve bolts and remove hypoid driven gear.(A)Hypoid driven gear2. Drive out the straight pin from differential assembly toward hypoid driven gear side.ST 899904100STRAI ...
Preparation tool
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Selec ...
Inspection
LIGHTING SYSTEM > Door SwitchINSPECTION1. Check the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnection diagram1 — 3When door is openedLess than 1 ?When door is closed1 M? or more2. Replace the switch assembly - door if the insp ...
