Subaru Crosstrek Service Manual: Dtc b1571 reference code incompatibility (immobilizer cm to ecm)

DTC detecting condition:

Incompatibility of reference code between keyless access CM (model without ID code box) or ID code box (model with ID code box) and ECM occurs.

Trouble symptom:

Engine will not start.

1.CHECK ECM.

Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

Is ECM registration finished? And does the engine start?

ECM registration was not performed properly.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1571 REFERENCE CODE INCOMPATIBILITY (IMMOBILIZER CM TO ECM)">Go to Step 2.

2.REPLACE ECM.

1) Install the ECM from other normal operating vehicle (with push button start) which use same ECM to the vehicle to be diagnosed.

2) Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

Is ECM registration finished? And does the engine start?

Replace the ECM. Engine Control Module (ECM) > REMOVAL"> Install the ECM from other vehicle to the original vehicle.

Replace Keyless access CM (model without ID code box), Keyless Access CM"> or replace ID code box (model with ID code box). ID Code Box">

Dtc b1577 imm control module eeprom

Dtc u0155 lost communication with instrument panel cluster (ipc) control module

Other materials:

Inspection
CLUTCH SYSTEM > Master CylinderINSPECTIONIf any damage, deformation, wear, swelling, rust or other faults are found on the cylinder, piston, push rod, nipple, return spring, bleeder screw, seat or hose, replace the faulty part.(A)Master cylinder body(B)Seat(C)Return spring(D)Piston(E)Piston stop ...

Dtc p0776 pressure control solenoid "b" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0776 PRESSURE CONTROL SOLENOID "B" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine spe ...

Disassembly
MECHANICAL(H4DO) > Chain CoverDISASSEMBLY1. Remove the oil filler cap.2. Remove the engine oil filter and the oil pump union. Engine Oil Filter > REMOVAL">3. Remove the oil pressure switch. Oil Pressure Switch > REMOVAL">4. Remove the engine oil temperature sensor. Engine ...