Subaru Crosstrek Owners Manual: Driving range on remaining fuel
- U.S.-spec. models
- Except U.S.-spec. models
The driving range indicates the distance that can be driven taking into account the amount of fuel remaining in the tank and the average rate of fuel consumption.
When the low fuel warning light illuminates, the driving range display flashes for 5 seconds. (The display first switches to the driving range value if a different value was previously displayed.)
- U.S.-spec. models
- Except U.S.-spec. models
If the driving range is shown as "
",
there is only a tiny amount of fuel left in the
tank. You must refuel the vehicle immediately.
NOTE
The driving range on remaining fuel is only a guide. The indicated value may differ from the actual driving range on remaining fuel, so you must immediately fill the tank when the low fuel warning light illuminates.
Driving information display
Information display selection knob
With the ignition switch in the "ON"
position, each successive press of the
information display selection knob
switches the display in the following seq ...
Average fuel consumption
U.S.-spec. models
Except U.S.-spec. models
This display shows the average rate of
fuel consumption since the trip meter was
last reset.
Trip knob
Pressing the trip knob toggle ...
Other materials:
Assembly
CONTROL SYSTEMS > MT Gear Shift LeverASSEMBLYNOTE:• Clean all the parts before assembly.• Apply NIGTIGHT LYW No. 2 grease or equivalent to each part. General Description > COMPONENT">1. Mount the bushing and cushion rubber to the stay.(A)Bushing(B)Stay(C)Cushion rubber2. I ...
System maintenance
NOTE
For the Subaru Ascent remote engine starter transceiver: if the vehicle battery
has been replaced, discharged, or disconnected, it is necessary to start the vehicle
manually at least once using the key or ignition system before the remote engine
start function can be used again. This ste ...
Disassembly
WIPER AND WASHER SYSTEMS > Wiper BladeDISASSEMBLY1. FRONTPull the side (a) of the wiper rubber stopper, and remove the rubber assembly - windshield wiper from the blade assembly - windshield wiper.2. REARSlightly pull the top of the rubber assembly - rear wiper from the stopper (a), and pull out ...
