Subaru Crosstrek Service Manual: Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump Chain
DISASSEMBLY
1. DRIVE SPROCKET
1. Remove the snap ring.
2. Remove the ball bearing using ST.
| ST1 498077600 | REMOVER |
| ST2 399513600 | INSTALLER |
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the torque co ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSPECTION• Check the oil pump chain for damage.• Replace if gear teeth are broken, damaged, sharpen or excessively worn.• ...
Other materials:
Disassembly
DRIVE SHAFT SYSTEM > Rear AxleDISASSEMBLY1. BUSHING - REAR AXLE HOUSINGDo not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.2. REAR BUSHING1. Remove the rear axle housing. Rear Axle > REMOVAL"&g ...
Initial illumination for system check
Several of the warning and indicator lights
illuminate when the ignition switch is
initially turned to the "ON" position. This
permits checking the operation of the
bulbs.
Apply the parking brake and turn the
ignition switch to the "ON" position. For
the system check, the following lights
...
Installation
BRAKE > Brake BoosterINSTALLATION1. Check and adjust the operating rod of the vacuum booster assembly.(1) Measure the length between the vacuum booster assembly mounting surface and clevis pin hole.(2) If it is not within the specification, loosen the lock nut, rotate the vacuum booster assembly ...
