Subaru Crosstrek Service Manual: Removal

1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">

2. Remove the torque converter assembly. Torque Converter Assembly > REMOVAL">

3. Remove the oil pump chain, oil pump sprocket, driven sprocket and oil pump chain cover.

NOTE:

Oil pump chain cover may be hard to remove because the driven sprocket is installed to the shaft side of the oil pump. Do not remove it forcibly. Remove it while holding the driven sprocket by hand.

4. Remove the seal rings.

5. Remove the driven sprocket from oil pump chain cover to remove the oil pump chain.

NOTE:

• The driven sprocket is replaced as an assembly only, because it is a non-disassembly part.

• If the ball bearing is removed from the driven sprocket, replace with a new part.

6. Remove the snap ring.

7. Remove the drive sprocket.

8. Remove the oil seal from the oil pump chain cover.

Assembly

Disassembly

Other materials:

Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...

STARLINKTM 7.0 Multimedia Plus audio set (U.S. spec. models only, if equipped)
The audio set will operate only when the ignition switch is in the "ACC" or "ON" position. For details about how to use the STARLINKTM 7.0 Multimedia Plus audio set, refer to the STARLINKTM 7.0 Multimedia Plus or STARLINKTM 7.0 Multimedia Navigation Owner's Manual. NOTE HD Radio Techn ...

Inspection
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD)INSPECTION1. MULTI-FUNCTION DISPLAY SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3 (UP)ENTER (DOWN)All OFF1 M? or more (UP)ONLess than 1 ?ENTERONA ...