Subaru Crosstrek Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0100 lost communication with ecm/pcm a
- Dtc b2222 system microcomputer fail
- Dtc u0101 lost communication with tcm
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0131 lost communication with power steering control module
- Dtc u0140 lost communication with body control module
- Dtc u0151 lost communication with restraints control module
- Dtc b2223 gerda malfunction
- Dtc u0164 lost communication with hvac control module
- Dtc u0327 software incompatibility with vehicle security control module
- Dtc b1500 fuel sender open/short-circuit detection
- Dtc b1507 external air temperature open/short-circuit detection
- Dtc b1501 power supply system error detection
- Dtc u0073 control module communication bus off
- Dtc u1201 can-hs counter abnormal
- Dtc u1650 invalid data received from meter (uart)
- Dtc u1651 lost communication with meter (uart)
- Dtc b2220 break the wire of ign
Dtc u0100 lost communication with ecm/pcm a
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from the engine co ...
Other materials:
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Steering ColumnINSTALLATIONCAUTION:If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode.– Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM&H ...
Selecting an audio source
1. Press the AUDIO/TUNE knob.
2. Select the desired source.
Example: Source select screen
NOTE
If the audio control screen appears,
select the "Source" key on the audio
screen or press the AUDIO/TUNE knob
again.
When you push the AUDIO/TUNE
knob while any screen other than t ...
Removal
LUBRICATION(H4DO) > Engine Oil FilterREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. OIL FILTER1. Turn the ignition switch to OFF.2. Remove the oil filter.NOTE:Clean off water or dust from the oil ...
