Subaru Crosstrek Service Manual: Control module i/o signal

Vehicle dynamics control (vdc) (diagnostics)

...

Electrical specification

VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Models without EyeSightNOTE:• Terminal numbers in VDCCM&H/U connector (on the contr ...

Other materials:

Switches and harness
Inspection Blind Spot Detection/Rear Cross Traffic Alert > Switches and HarnessINSPECTIONBSD/RCTA OFF switch1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply ba ...

Removal
SECURITY AND LOCKS > Immobilizer AntennaREMOVAL1. MODEL WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to right and left.(2) Release the claw, and re ...

When checking or servicing in the engine compartment
CAUTION Do not contact the drive belt cover while checking the components in the engine compartment. Doing so may cause your hand to slip off the cover and result in an unexpected injury. Do not touch the oil filter until the engine has cooled down completely. Doing so m ...