Subaru Crosstrek Owners Manual: Connecting a Bluetooth device
To use the Bluetooth audio system, it is necessary to register a Bluetooth device with the system.
Registering an additional device
1. Select the "Add" key on the Bluetooth devices connection screen.
2. For more information: Refer to "Registering/ connecting Bluetoothdevice" F5- 65.
- Selecting a registered device
1. Select the "Select" key on the Bluetooth devices connection screen.
2. For more information: Refer to "BT Devices Connection screen"
How to change the source
Select the "BT Audio" key on the source select screen. Refer to "Selecting an audio source"
NOTE
Depending on the type of portable player connected, some functions may not be available and/or the screen may look differently than shown in this manual.
Control screen and audio panel
Select to display the audio source
selection screen.
Select to display the play mode
currently selected. Refer to "Select
play mode"
Select to display as a list (for the
models with ...
Select play mode
The play mode settings display will appear
when play mode key is touched. Select
the preferred play mode from the following
items.
Icon
Function
Touch to start 1 track repea ...
Other materials:
Diagnostic procedure with cancel code Dtc b2328 rear radar internal failure (radar misalignment)
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Cancel CodeDTC B2328 REAR RADAR INTERNAL FAILURE (RADAR MISALIGNMENT)DETECTING CONDITION:• Excessive impact was given to the installation area of the radar sensor, which resulted in deviation of the rada ...
Removal
GLASS/WINDOWS/MIRRORS > Rear Regulator and Motor AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL">4. Remove the glass ...
Caution
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTIONAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage the ...
