Subaru Crosstrek Service Manual: Clear memory mode Operation
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Brake Control System».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Check list for interview Check
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Check List for InterviewCHECKCheck the following item about the vehicle’s state.1. STATE OF ABS WARNING LIGHTABS warning light illuminates. Alwa ...
Electrical component location Location
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)VDC control module and hydraulic control unit (VDCCM&H/U)(7)VDC OFF indicator light(12)ABS wheel speed sen ...
Other materials:
Dtc c2123 transmitter 3 no data
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2123 TRANSMITTER 3 NO DATANOTE:Refer to DTC C2124 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2124 TRANSMITTER 4 NO DATA"> ...
Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATION• For detailed operation procedures, refer to “Application help”.• If the auto headlight beam leveler CM can not communicate with Subaru Select Monitor, perform “COMMUNICATION FOR INITIA ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check board connector.Connector & terminalNo. 14 (+) — No. 42 (−):(A)+ probe(B)− probe3 ...
