Subaru Crosstrek Service Manual: Clear memory mode Operation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Keyless Access with Push Button Start» and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
• For detailed operation procedures, refer to “Application help”.
• Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
Check list for interview Check
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Check List for InterviewCHECKInspect the following items regarding the vehicle’s state.Keyless Access with Push Button Start Syste ...
Diagnostics with phenomenon Inspection
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostics with PhenomenonINSPECTION1. KEYLESS ACCESS LOCK/UNLOCK CANNOT BE PERFORMED FROM ANY OF THE DOORSCAUTION:• Check that t ...
Other materials:
Interior lights
CAUTION
When exiting your Subaru Ascent, always ensure that all interior lights are
switched off to prevent unnecessary battery discharge and maintain proper vehicle
readiness.
Map lights
Door interlock switch
In the Subaru Ascent, the map lights provide convenient illumination for ...
Installation
BRAKE > Stop Light SwitchINSTALLATION1. BULB TYPE1. Install the stop light switch.CAUTION:• Turn the stop light switch clockwise when installing so that it can return backward by approximately 1 mm (0.04 in) and clearance is automatically adjusted.• If it is hard to turn the switch, r ...
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyDISASSEMBLYNOTE:Attach a cloth to the end of driven shaft (on the frictional side of the thrust needle bearing) to prevent damage during disassembly or reassembly.1. Flatten the tab of the lock nut. Remove the lock nut with ST ...
